Got a lot of PWM fans and want to control it the easy way? Use the PWM functionality on your motherboard!

It is designed for enthusiasts with need for controlling numerous system fans
Capable of expanding one motherboard PWM fan header to support up to ten fans. 
Header of CPU fan is just for PRM signal return to motherboard, and Fan1~Fan 10  are powered by the Molex 4pin or SATA connector from computer PSU (make your choice from menu above).

Compatible with 3-pin / 4-pin Fans  (Due 3pins no PWM controller, 3pin fans would run in full speed).
Comes with self adhesive film for easy installation and options to hide the PCB in your case.
Since only one RPM signal can be read by one motherboard connector, only 'CPU Fan' channel of the PWM splitter carries an RPM signal; thus the motherboard will only read the RPM signal of the PWM device that is connected to channel 1 of the splitter.
 
Specification
Type : 10 port/channel/way 4pin PWM fan hub
Power by: Molex 4-pin or SATA (choose from menu above)
Connector A: Red CPU 4pin header for CPU 4-pin/3-pin fan
Connector B: Fan-0~Fan-9,  4pin header for 4-pin/3-pin case fan
Connector C: PWM header for RPM signal return to motherboard and PWM controlling
Cable : 60CM 2pin cable with locking for PWM header to motherboard connection

Note:
Only the fan on 'CPU Fan' channel is used for monitoring. 
All connected fans are following the same PWM signal, so speed control is the same for all fans when using fan controller software like ASUS AI suite/Xpert FAN, EASY TUNE, etc.
PWM connectors must be 4-pin, but not all 4-pin motherboard connectors are enabled for the PWM signal modulation by default. Please carefully consult your motherboard manual.
 
This is only a fan hub, NOT fan speed controller,
Only 4-Pin PWM fans speed can be adjusted by fan controller software, 3-Pin fan would run in full speed and cannot be adjusted through this PCB.