Features:

• D5 Vario Pump Motor Only.
• This pump can be adjusted in 5 steps
  • P1 = 1.800 rpm
  • P2 = 2.550 rpm
  • P3 = 3.300 rpm
  • P4 = 4.050 rpm
  • P5 = 4.800 rpm

Specifications:

• Supply voltage: 8-24V DC
• Ambient temperature: 10-50°C
• Electrical Connector: Molex 4 Pin
• Cable: 580 mm ±10 mm

Please confirm the wire position if you need to replace it.

Download Installation Guide

*** Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product. ***

*** From 15th March 2018, all of our installation guides will be provided electronically via an easy-to-use QR code attached to the packaging. ***
*** Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test with only the pump connected to the power supply. ***
*** When using the leak tester on a water cooling loop, in order to avoid product damage due to excessive pressure, the input pressure should not exceed 0.5kg/cm2 (bar), and do not over 30 second. The leak tester must not be used when there is water in the loop or when the pump is running. If the product is damaged due to excessive pressure or incorrect use, Bitspower's product warranty will be null and void, and the cost of any damage to the hardware will be borne by the customer. ***
Last updated : 2021-08-31 11:20:02