WORLDWIDE SHIPPING with GLS, DPD, PostNL & UPS. We ship to every country! Your country not listed? Please contact us.

EK-Loop D5 MX PWM Motor

 -   - 
Our price:  61,95  (51,20  excl tax)
Price in points: 256 points
Reward points: 5 points

EK-Loop D5 MX PWM Motor is a low-power version of the full D5 water pump with PWM speed control via the motherboard or a dedicated fan/pump controller. Compared to the full-power D5 G3, it has a 20% lower flow rate and a weaker head pressure. It uses less power, with only a 15W power draw. Also, power is drawn via Molex connector compared to the SATA on the G3.

EK-Loop D5 MX PWM is an original Xylem D5 PWM pump, with a reduced power draw.

PWM control allows for automatic pump speed regulation depending on your CPU temperature. Full performance on demand or whisper-quiet operation in idle mode!

This pump is ideal for PC and other electronics water cooling. The D5 pump is equipped with an electronically commutated spherical motor. In a pump with a spherical motor, the only moving part is a spherically shaped rotor held in place by a bearing ball made of ultra-hard and wear-resistant ceramic.

The magnetic rotor always balances itself ideally on the ceramic bearing. The pump is very robust and the parts exposed to the fluid are corrosion-resistant, which provides an exceptionally long service time.

This product is compatible with any product that supports D5 pumps, including:
- EK-Quantum Kinetic TBE D5 series
- EK-Quantum Kinetic FLT D5 series
- EK-Quantum Inertia D5 series
- EK-Quantum Reflection and Reflection²
- EK-XTOP Revo Dual D5 PWM Serial (incl. 2x pump)

Technical specifications:
- Motor: Electronically commuted spherical motor
- Rated voltage: 12V DC
- Power consumption: 15W
- Maximum head pressure: 2.6m
- Maximum flow: 1200L/h
- Maximum liquid temperature: 60°C
- Cable color: Black
- Power connector: Molex power and 4-pin PWM FAN connector

Operational regime:
- PWM duty cycle: ~ 20-100%
- Default behavior: Runs at 100% duty cycle when no PWM feedback signal is present

 Made in the EU.

PLEASE NOTE:

  • Only pump motor is shipped!
  • This product is compatible with any EK-D5 pump top and reservoir.
  • The D5 pump is water lubricated and it must not be run dry; otherwise, permanent bearing damage can occur.
  • This product should NOT be installed with any aluminum Fluid Gaming parts!
Manufacturer:
EK Waterblocks

No posts found

Write a review
As soon as the price of the products decreases, you will immediately know about it.
Keep track of price reductions

The price has not changed yet. We will show it on this chart once it changes