Bitspower Sedna Torque for Antec Torque Case (P5D)

Owners of Antec Torque cases, Bitspower has you covered for your water reservoir and pump needs with the Bitspower Sedna Torque. While being a perfect fit within this mid-tower chassis, the reservoir’s  pump is dissimulated at the back in order to provide an unaltered look to your PC.

With novice modders in mind, Bitspower designed a reservoir that is easy to install while providing a professional look. Equipped with multiple water inlets and outlets to route the water from the radiator to the VGA than the CPU, this reservoirs also gives you more playroom for the graphics card location with a dual inlet/outlet designed to prevent having to bend more tubes and create a cleaner look to your loop.

The Bitspower Sedna Torque, equipped with Bitspower Digital RGB LED, is sure to become the center of attention of your case with bright LEDs that are are certified by ASUS AURA Sync, GIGABYTE RGB Fusion 2.0, MSI Mystic Light Sync, ASRock Polychrome, BIOSTAR VIVID LED DJ and Razer Chroma.

LED Color : Digital RGB
LED Strip Management By Bitspower Digital RGB And Certified By ASUS AURA Sync, GIGABYTE RGB Fusion, MSI Mystic Light Sync, ASRock Polychrome, BIOSTAR VIVID LED DJ and Razer Chroma

Compatibility :
Antec Torque Case

Included :
1set of BPTA-WDPTORQUE-R-P5D
1pcs of BPTA-EFW-V2-GS   
1pcs of BPTA-EXAIR-GS

P5D Pump Spec
Rated voltage：12V DC
Power consumption：20W
Maximum flow：14.5±15% L/min
Noise：≤40dBA
Ambient temperature：-25~70℃
PWM：Yes
MTBF：15,000 hours
Warranty：2 years

◆DRGB
The end of power supply is 3PIN. The sequence is +/D/↓ (some motherboards are shown +5V/D/↓, and the plug is like 4PIN but the 3rd PIN is empty). Please plug in the corresponding direction of motherboard, controller or the wire integrator for one to many. If choosing the motherboard as the power supply, the light effect can be synchronize with MB.

*** Bitspower reserves the right to change the product design and interpretations. These are subject to change without notice. Product colors and accessories are based on the actual product. ***
*** From 15th March 2018, all of our installation guides will be provided electronically via an easy-to-use QR code attached to the packaging. ***
*** Before filling in the water, please make sure all the components are installed correctly. To prevent any leakage which may damage the PC components, please perform a 24-hour leaking test with only the pump connected to the power supply. ***
*** When using the leak tester on a water cooling loop, in order to avoid product damage due to excessive pressure, the input pressure should not exceed 0.5kg/cm2 (bar), and do not over 30 second. The leak tester must not be used when there is water in the loop or when the pump is running. If the product is damaged due to excessive pressure or incorrect use, Bitspower's product warranty will be null and void, and the cost of any damage to the hardware will be borne by the customer. ***
Last updated : 2023-11-17 09:00:01